User Manual for Maisto 19160RCA Radio Control Vehicle

Quick guide from the manual

This document provides essential instructions for operating your Maisto Radio Control Vehicle. The vehicle features a built-in rechargeable battery and requires a separate controller powered by 1.5V AAA batteries. Proper synchronization between the controller and the vehicle is required for operation.

Package Contents

• RC Vehicle with built-in rechargeable battery
• Controller
• USB Cable
• Owner's Instruction Manual

Note: 2 x 1.5V AAA batteries for the controller are not included.

Charging the Vehicle

1. Open the charging port cover on the vehicle.
2. Ensure the power switch is set to the CHARGE position.
3. Connect the USB charging plug to a certified USB port.
4. The charge LED indicator will flash green while charging.
5. When the LED stays solid green, the battery is fully charged.
6. Disconnect the USB cable and replace the charging port cover.

Controller Setup

1. Ensure the power switch on the controller is in the OFF position.
2. Use a screwdriver to loosen the screw on the battery cover.
3. Install 2 new 1.5V AAA batteries, ensuring correct polarity (+/-) as shown inside the compartment.
4. Replace the battery cover and tighten the screw.

Operation and Pairing

1. Switch both the controller and the vehicle to the ON position.
2. The Power LED on both units will flash for less than 3 seconds and then stay on, indicating that automatic frequency matching is complete.
3. Use the trigger on the transmitter to drive the vehicle forward or backward.
4. Use the steering wheel to control the vehicle's direction (left/right) or to perform 360-degree spins.
5. Always turn the switches on both the controller and vehicle to OFF when not in use.

Performance Tips

• Do not drive the vehicle on grass, sand, or through water.
• Avoid driving in windy or rainy weather.
• Keep fingers, hair, and loose clothing away from the vehicle.
• The operating range can be affected by weak batteries or interference from other R/C items, CB radios, or high-voltage transmitters.

Safety and Maintenance

• The built-in battery must be charged before use.
• Do not charge the battery for more than 1.5 hours (except for the initial two charges).
• Do not touch the vehicle when it is hot; allow it to cool before recharging.
• Do not dispose of the battery in fire.
• Regularly examine the USB cable for damage to the cord, plug, or enclosure.
• Rechargeable batteries are to be removed from the toy before being charged (for the transmitter, if applicable).