User Manual for Maisto 19181RCA RC Vehicle

Quick guide from the manual

This guide provides essential instructions for operating your Maisto RC vehicle. Before first use, ensure the built-in battery is fully charged and the controller is equipped with fresh batteries. The vehicle and controller automatically sync when both are switched to the ON position.

Package contents

• 1 x RC Vehicle with built-in rechargeable battery
• 1 x Controller
• 1 x Owner's Instruction Manual
• Note: 2 x 1.5V AAA (LR03/R03) batteries for the controller are not included.

Charging the vehicle

1. Ensure the vehicle power switch is in the OFF/CHARGE position.
2. Open the battery compartment cover on the bottom of the vehicle to access the USB cable.
3. Connect the USB plug to a certified USB port.
4. The LED indicator will light up red to indicate charging.
5. Once the LED turns off, the vehicle is fully charged.
6. Disconnect the USB cable, store it back in the compartment, and replace the cover.

Controller setup

1. Use a screwdriver to loosen the screw on the battery cover.
2. Insert 2 new 1.5V AAA (LR03/R03) batteries, ensuring correct polarity (+/-).
3. Replace the battery cover and tighten the screw.

Operation

Syncing: Set the power switch on both the controller and the vehicle to the ON position. The Power LED on the vehicle will flash for less than 3 seconds and then stay on, indicating the automatic frequency matching is complete.

Driving:

• Pull the trigger on the transmitter to drive the vehicle forward.
• Push the trigger on the transmitter to drive the vehicle backward.
• Turn the transmitter steering wheel to move the vehicle left or right.

Performance tips and maintenance

• Do not drive on grass, sand, or through water.
• Avoid driving in windy or rainy weather.
• Keep fingers, hair, and loose clothing away from the vehicle.
• If the vehicle does not run in a straight line, adjust the wheel alignment lever located under the chassis.
• Turn the switch of the controller and vehicle to the OFF position when not in use.

Cautions

• The built-in rechargeable battery must be charged before use.
• Do not overcharge the battery; do not charge for more than 1.5 hours except for the initial two charges.
• Do not charge the battery if it shows leakage, corrosion, or has loose/exposed wires.
• Do not cover the vehicle with any material while charging.
• Do not touch the vehicle immediately after use if it is hot; allow it to cool before recharging.