Safety Instructions for Neomounts DS60-600BL2-1 Triple Monitor Arm

Important Safety Information

This document provides essential safety warnings and instructions for the Neomounts DS60-600BL2-1 triple monitor arm. Failure to follow these instructions may result in serious personal injury, equipment damage, or voiding of the factory warranty.

• Qualified Personnel: Installation must be performed by qualified and authorized service personnel.
• Two-Person Installation: Always involve two people when installing or removing the product to prevent injury or damage.
• Indoor Use Only: The product is designed exclusively for indoor use.
• Safety Inspection: Perform periodic inspections of the product, its fixings, and the contact surface at least every six months.

Installation Requirements

Before installing the monitor arm, ensure the following conditions are met:

• Surface Strength: Inspect the mounting surface to ensure it is strong enough to support the equipment. The product must be fixed to a suitable-sized, undamaged tabletop.
• Environment: Do not install the product in areas subject to shock, vibration, high temperatures, humidity, or contact with water. Avoid locations near air conditioning vents or areas with excessive dust and fumes.
• Tools: Use appropriate tools and equipment during installation to avoid injury.
• Parts: Use only the original mounting parts provided with the product.

Usage and Adjustments

To ensure safe operation and prevent damage to your equipment:

• Weight Limits: Ensure the load applied to the product stays within the specified minimum and maximum limits. Failure to follow these specifications can lead to serious injury or damage.
• Adjustment Safety: Keep hands, fingers, and body parts clear of moving mechanisms during adjustment.
• Stability: Do not rotate the monitor past the rear edge of the desk, as this can create an unstable situation.
• Cable Management: Leave enough slack in the display cable to allow for the full range of motion and avoid cable pinching.
• Weight/Height Settings: Ensure weight and height settings are adjusted after installation. Repeat this process whenever monitors or other equipment are added or removed.
• Rapid Movement: If the mounted monitor is too heavy or not properly adjusted, the product may move down rapidly.

Maintenance and Care

• Cleaning: Do not use solvents or cleaning agents to clean the product.
• Disposal: Dispose of packaging materials and product parts in accordance with local regulations.
• Prohibitions: Do not hang on the unit. Remove all equipment before detaching the product from the desk.