User Manual for Uniview 0231C1GD Card Reader

Quick guide from the manual

This document provides essential information for the installation and operation of the Uniview 0231C1GD Card Reader. The device supports both Wiegand and RS485 communication modes. The reader is designed for professional installation and requires a 12V power supply. Ensure all wiring is planned before installation and that you have the necessary tools, such as a Phillips screwdriver.

Packing List

Before beginning installation, ensure the package contains the following items:

• Card reader
• Screw components (2 sets)
• Mounting bracket
• Product documents

If the package is damaged or incomplete, contact your local dealer.

Product Overview

The card reader is available in two versions: with a keypad and without a keypad. Both versions share the same dimensions (129mm x 88mm x 21mm) and wiring configuration.

Wiring and Connections

The device uses a set of tail cables for connectivity. The card reader operates in Wiegand mode by default.

• Red: VDD12V (Power interface)
• Black: GND (Grounding interface)
• Orange: RS485_A (RS485 interface)
• Yellow: RS485_B (RS485 interface)
• Blue: WIEGAND_MODE (Switch Wiegand signals)
• Pink: TAMPER (Report tamper alarms)
• Grey: WIEGAND_BUZZER (Beep control)
• White: WIEGAND_OK (Green LED control)
• Purple: WIEGAND_ERR (Red LED control)
• Brown: WIEGAND_OUT0 (Wiegand output interface)
• Green: WIEGAND_OUT1 (Wiegand output interface)

Note: To switch to RS485 mode, both WIEGAND_OK and WIEGAND_ERR must be set to a low voltage level. In this mode, WIEGAND_OUT0, WIEGAND_OUT1, WIEGAND_BUZZER, and WIEGAND_MODE are used to indicate the RS485 address.

Status Description

The device provides visual and audible feedback:

• Blink blue, green, and red in sequence: Device startup complete.
• Steady blue: Operating normally.
• Steady green for 1s: Card authentication succeeded.
• Steady red for 1s: Card authentication failed.
• Constant beeps: Tamper alarm triggered.

Device Installation

The installation process is the same for both keypad and non-keypad models.

1. Preparation: Ensure you have an 86x86mm or 115x73mm junction box installed in the wall.
2. Mounting the bracket: Align the bracket with the junction box holes. Ensure the protruding side faces you and fasten it using Phillips screws.
3. Wiring: Connect the tail cables and lead them through the center hole of the bracket into the junction box.
4. Mounting the reader: Align the slots on the card reader with the protrusions on the bracket. Insert the reader and secure it with a screw through the bottom hole.

Startup

After installation, connect the power adapter to the card reader's power interface. A successful startup is indicated by the indicator light blinking blue, green, and red in sequence, accompanied by a beep.

Safety and Security

To ensure device security, it is recommended to change the default password, keep firmware updated, and disable unused features like UPnP or Multicast if not required. Always install the device in a proper environment, protect it from liquids, and ensure adequate ventilation.