Installation Instructions for Vista 1054WM Linear Floodlight

Quick guide from the manual

This document provides installation instructions for the Vista 1054WM Commercial Series Linear Floodlight. The luminaire is designed for above-grade installation only and must be installed in accordance with the National Electrical Code (NEC) and local codes. The unit supports 0-10V dimming and allows for +/- 15 degrees of aiming adjustment from the horizontal position.

Safety Warnings

• Hot Surface: The luminaire can become hot during operation. Use caution when selecting the installation location.
• Electrical Safety: Always ensure the electrical supply is turned off at the circuit breaker before beginning installation or servicing.
• Compliance: Installation must be performed by qualified personnel in compliance with NEC and local electrical codes.
• Connections: Use only UL-recognized wire connectors.

Installation: Recessed 4-0 Box

1. Ensure power is off at the circuit breaker.
2. Identify the two mounting holes on the Wall Mount Plate that will be used.
3. Install two 8-32 Mount Screws through the Wall Mount Plate and 4-0 Gasket into the unused holes, securing them with Washers and 8-32 Hex Stand-Offs. Tighten by hand.
4. Route the luminaire load conductors into the recessed 4-0 box.
5. Connect supply conductors to load conductors (see Wiring section).
6. Affix the Wall Mount Plate to the 4-0 box using the remaining two 8-32 Mount Screws. Tighten securely.

Installation: Weatherproof Outlet Box

1. Ensure power is off at the circuit breaker.
2. Route the luminaire load conductors into the Weatherproof Outlet Box.
3. Connect supply conductors to load conductors (see Wiring section).
4. Affix the Wall Mount Plate to the Weatherproof Outlet Box using four 10-24 Mount Screws. Tighten securely.

Wiring and Connections

Connect the supply conductors to the luminaire load conductors observing the following polarity:

• Supply (+) to Load (Black)
• Supply (-) to Load (White)
• Supply (Ground) to Load (Green)

If using 0-10V dimming:

• Dimming Supply (+) to Dimming Load (Purple)
• Dimming Supply (-) to Dimming Load (Grey)

Aiming and Adjustment

1. Once mounted, adjust the aim of the luminaire up to +/- 15 degrees from the horizontal position.
2. Firmly re-tighten the Aiming Adjustment Screw to hold the position.
3. Lock the desired aiming by firmly tightening the two Set Screws located on both sides of the Wall Mount Plate.
4. Restore power and verify proper operation.

Maintenance

To ensure proper operation and efficiency, the lens must be kept clean and free of dirt, dust, leaves, trash, and mineral deposits from water. A regular scheduled maintenance program is recommended.